Attic mold removal cleans or removes mold from roof sheathing, rafters and insulation, then corrects the ventilation or leak that fed it. In Philadelphia the usual cause is winter condensation or a slow roof leak. Call the number on this page to be connected with a local mold company in Philadelphia.

Why attics grow mold
Philadelphia winters are cold and its summers are humid. Warm indoor air leaks up through ceilings into the attic, meets cold roof sheathing and condenses. Bath fans vented into the attic, blocked soffits and thin or crushed insulation make it worse. A failed flashing or a leaking roof does the same job with liquid water. EPA's guide says mold will keep returning unless the moisture problem is fixed, so removal alone is only half the work.
What the work involves
A company typically checks the roof deck and insulation, seals off the attic hatch, and runs air filtration. Light growth on sheathing may be cleaned with HEPA vacuuming and wire brushing or sanding. Heavily soaked insulation is bagged and removed, and rotted boards are replaced. Afterward the crew or a roofer should correct ventilation, bath-fan ducts and air sealing at the ceiling.
Philadelphia rowhouse and twin attics
Many Philadelphia rowhouses and twins have shallow attics, flat or low-slope roofs and party walls shared with neighbors. Access can be a tiny hatch, and a leak next door can travel along the shared wall. Older homes often have bath and kitchen fans that exhaust into the cavity rather than outdoors. Ask any company you speak with how it will keep dust out of your living space.
What it costs
National cost guides list roughly $1,000 to $4,000 for attic mold removal, and $1,500 to $6,000 for a partial attic or $6,000 to $15,000 for a full attic. These are national figures, not Philadelphia quotes, and roof repair or insulation replacement is usually extra.

Pennsylvania checks
The Pennsylvania Department of Health says there are no federal or Pennsylvania state regulations about mold, so there is no state mold license to look up. Instead, confirm the company is registered with the Pennsylvania Attorney General as a home improvement contractor: the "PA" number must appear on contracts and ads, and work over $500 needs a written contract with a three-day right to cancel. In the city, Philadelphia requires a contractor license for businesses outside the one- and two-family exemption, and L&I says ordinary maintenance repairs generally need no permit while larger structural repairs may.
If you're across the river in New Jersey or in Delaware, the rules differ. See also mold inspection and duct mold removal.
Attic Mold Removal questions from Philadelphia homeowners
What causes mold in a Philadelphia attic?
How much does attic mold removal cost?
Do mold companies in Pennsylvania need a mold license?
Will the mold come back after cleanup?
Related mold services in Philadelphia
Helpful guides
Attic Mold Removal in nearby cities and towns
Bucks County
Montgomery County
Delaware County
Chester County
Camden County
Burlington County
Gloucester County
Mercer County
Hunterdon County
New Castle County
Sources
Last updated: