Small surface growth under about 10 square feet is something a homeowner can usually clean, per EPA guidance. After a flood, though, the affected area is often much larger and includes materials inside the walls. Call the number on this page to be connected with a local mold company in Drexel Hill.

When to stop DIY
EPA says a homeowner can usually handle an area under about 10 square feet. If water reached the walls, covered the floor of a room or came from a sewer line, the job is larger and the materials involved usually need professional removal. Err on the side of calling early.
Sewer backups
When a municipal line is overloaded or a lateral clogs, wastewater comes up through floor drains and low fixtures. Companies treat these events more carefully than clean-water leaks and remove porous materials that touched the water, because they cannot be reliably cleaned. Ask what category of water you had.

Salvage versus tear-out
Framing, concrete and many hard surfaces can be dried and cleaned. Carpet, pad, insulation and drywall that stayed wet are usually removed. The more that can be saved, the smaller the cost, which is why fast drying makes such a difference. Ask who handles that work.
Your part in the process
Be ready to move belongings, shut off the HVAC system for the work area and keep children and pets away. In rowhouses and twins, mention the work to neighbors, since noise and equipment may carry through the shared wall. Ask who decides when the space is clear.
Before work starts in Drexel Hill
Pennsylvania's Department of Health says there are no federal or state regulations about mold, so no state mold license exists to look up. What you can check is the company's home improvement contractor registration with the Pennsylvania Attorney General.
Ask whether the company that removes the mold will also test its own work. Many owners prefer an independent assessor for clearance.
If the job grows into replacing drywall, cabinets or framing, ask whether the rebuild needs a permit from the Upper Darby Township building office.
If river, creek or storm water got inside, FEMA's flood map service and your insurer can tell you how the address is zoned.
Companies that take calls here usually also work in Clifton Heights, Lansdowne and Upper Darby.
Test your sump pump
Pour a bucket of water into the pit each season and watch the float lift and the pump cycle. Clear the discharge line, check that it empties well away from the house and consider a battery backup for outages during storms. Do it before storm season, not during.
Storm & Flood Mold Removal questions in Drexel Hill
My sump pump failed. What now?
How long does it take to dry out after a flood?
How soon should I call after the water is gone?
Will mold come back after cleanup?
More mold services in Drexel Hill
Storm & Flood Mold Removal nearby
Helpful guides
Sources
Last updated: